Bringup procedure of a real device

Development archive
1

Sorry, I have forgotten to post the forked theads:

ps          pid | name | state Q | pri | stack ( used) | location            1 | idle | pending Q | 15 | 256 ( 148) | 0x20000298            2 | main | running Q | 7 | 1536 ( 792) | 0x20000398            3 | pktdump | bl rx _ | 6 | 1536 ( 256) | 0x20001924            4 | 6lo | bl rx _ | 3 | 1024 ( 468) | 0x20001f38            5 | ipv6 | bl rx _ | 4 | 1024 ( 420) | 0x20000e60            6 | udp | bl rx _ | 5 | 1024 ( 296) | 0x200026e4            7 | at86rfxx | bl rx _ | 3 | 1024 ( 412) | 0x200009f0              > SUM | | | 7424 ( 2792) >

Thanks for any hint!

Best regards, Bernhard

2

Hello Bernhard,

Did you change L2(HWaddr) address on one board? since you are mentioning only IP address change. Check for AT86RF2XX_DEFAULT_ADDR_LONG.

To see the 802.15.4. traffic in the air you would need some kind of 802.15.4 sniffer…

wbr malo